Gives your t-case a warm, fuzzy and secure feeling by wrapping around the t-case and being secured with either 22, 17 OR 14 t-case bolts. 14 is for when you have rear t-case disc, drum brake or a rear drive shaft disconnect. Simply cut off the back t-case output plate.
Eliminates the factory 3 t-case rubber blocks and aftermarket gadgetry that can break or pull through the frame. The main cradle has 4 poly horizontal mounts using four 1/2" thick bolts. Basically the same mounts your suspension uses to hold the entire vehicle up. We were first and still the only direct to public wholesale manufacturer to solidly mount to frame and then transfer the cradle rotational energy into 4 higher corners.
This may be the most recommended cradle by dedicated Suzuki people. If you have or plan on installing lower gears or any bolt on accessories to the rear output shaft. Allows the room to fit the SJ-410 drum emergency brake, the after-market disc emergency brake or the after-market rear drive shaft disconnect products.
Moderately easy to install and remove once the t-case is secured in the cradle. Places the t-case in the correct factory position.
Can easily be adapted to tube chassis buggies.
MOUNTING:
All mounting hardware is included. Full installation instructions on the ZOR you tube channel.
FINISH OPTIONS:
This unit is shipped bare naked metal ONLY! Use Rustoleum "Hammered" paint for the best finish.
